CAS Support - Cowboy Gun Works

ATTENTION UBERTI ’73 & ’66 RIFLE USERS SHOOTING .38 SPECIALS

Even if your rifle has been slicked up, do you ever notice a slight “hitch” in the action?

Well Cowboy Gunworks has the answer why and the solution.

The Uberti rifles are made with the same sized magazine tube for both the .45 Colt and the .38 Special/.357 Magnum. The result is that when the .45 Colts are loaded into the magazine they line up pretty well.

However in your .38 Special rifle they look like this:

Wedging and hang-ups can occur and that results in the hitch in the action.

With the Cowboy Gunworks Smooth Cycle Sleeve Kit your .38 Special cartridges line up like this:

The Cowboy Gunworks Smooth Cycle Sleeve Kit contains a precision aluminum sleeve tube, a stainless steel magazine spring, and a precision stainless steel follower.

The Kit is an easy drop-in installation. Simply remove the Magazine End Cap. Remove the old spring and follower. Drop in the Smooth Cycle Sleeve aluminum tube then drop in the stainless follower followed by the new stainless magazine spring and re-install the End Cap.

How to measure for the tube ...
The photo demonstrates the proper way to measure the barrel length on your Uberti Rifle for the 'Smooth Cycle Sleeve'. Drop the tape measure on top front of the carrier as shown and measure to the end of the barrel.

Price -----------------------------------------------------$79.00, plus shipping.

(Note: Both of these drawings are exactly to scale.)

Stainless Steel Magazine Tube Spring for all 1873, Marlin, and 1892 rifles. $25.00 each

Stainless Steel Magazine Tube Follower for all 1873, Marlin, and 1892 rifles. $25.00 each

Brass Bead Front Sights $25.00 each 3/32 Brass Bead Front Sight.
(Helps shooter maintain focus on the front sight.)

Rifle Upgrades